Skip to main content

Tutorial: How to wind a ball of yarn from a skein

The first time I saw a skein of yarn I wasn't sure exactly what to do with it.  I was used to using balls of yarn and it was totally new to me.  Needless to say, I ended up with a huge tangled mess that took me hours to untangle and if the yarn wasn't so expensive, I would have just thrown it away instead of untangling it for ages.  But, if you know what to do with it, a skein is really easy to work with.  There are two ways I do this depending on where I am: 1.) when I am at home, I use an umbrella swift and ball winder and/or 2.) when I'm not home, (and before I got the yarn swift and ball winder) I use my legs...that's it.

For the umbrella swift and ball winder method-

I have this umbrella swift and this ball winder.  I got them as a Christmas gift off of my Amazon Wish List.  At first I was hesitant to put them on there because they are expensive but I am so glad I did, I love using them!

First you unwind your skein.




Next look closely and find the point(s) where the skein is tied and untie it.  In some lace weight yarn, it is tied in numerous places but in thicker yarns its only once.




Once you have it untied, carefully lift it onto the umbrella swift and secure the swift.


Then set up the yarn on your ball winder as per the directions that came with it.



Next start winding.

  


When you are finished, which will only take a few minutes, you end up with this-


Slip it off of the center of the winder and you end up with a beautiful center-pull cake.



For the low-tech "leg" method-

You start in the same way, first, you unwind your skein.

  


Next look closely and find the point(s) where the skein is tied and untie it.  Again, in some lace weight yarns, it is tied in numerous places but in thicker yarns its only once.



Now, I sit on the floor with my back leaning against something comfortable and bend my knees up then carefully lift the untied skein onto your legs.  Spread your legs out to the sides until the yarn is pulled tight.  That is important.  If there is not enough tension on the yarn, you will end up with a tangled mess.



Then you unwind a few rounds from your legs and start forming a ball.  When I start my ball, I wrap the yarn around two fingers a few times then I pull that off and fold it in half and then use that as my base for the ball and continue winding on that.



Continue in this fashion- unwind a few rounds from your legs (don't do too much at once of it will tangle), and then wrap it around the growing ball of yarn.  I usually do ten or so wraps in one direction, then turn the ball slightly and do ten more and so on.




Each time I turn the ball, I make sure its growing evenly at all angles.  Keep going until you have used up all the yarn on your legs and you end up with this-



Both ways work, and while a ball winder gives you beautiful center-pull balls of yarn, the leg method still gets the job done and leaves you with a nice ball of workable yarn.


Comments

Post a Comment

Popular posts from this blog

Tutorial: How to Add a Zipper to a Crochet Pouch

I have been crocheting tons of pouches lately and I love lining them with a coordinating fabric and finishing them with a zipper.  I'm not an expert at sewing by any means, but this method works for me.  I use it every time and I am always happy with the results.  I hope you enjoy this tutorial! In the pictures shown in this tutorial, I am lining the Lee Change Purse .  But, this method will work for any pouch...just adjust the fabric and zipper sizes. Materials needed- for the fabric lining & zipper (if desired): • 5" zipper • Fabric- 2 pieces that are roughly 5" high by 6"wide •Needle & thread •Sewing machine (optional) •a few ball head straight pins Finished size: • Lee Change Purse- 4" high by 5" wide Making the Lining: 1. Cut out 2 pieces of fabric that are about 1/2-inch larger around than your pouch. 2. Lay one piece of the fabric, right side up, on your worktop.  Place the zipper, right side up, on top of t

Free Crochet Pattern: Emerson Car Seat Cover or Baby Blanket

I love the concept of car seat covers/canopies.  When you use a regular blanket instead, it is always falling off and you are constantly picking it up off the ground.  A car seat cover covers and protects your baby for cold weather, rain, snow, bright sun, you name it and it hooks on the handle bar so it ALWAYS stays in place!  I absolutely love it and if you have a baby in an infant seat, you NEED to make one of these to see how great it is. PLEASE REMEMBER, it is dangerous to have your baby covered up in their car seat for long periods of time.  This cover is NOT meant for that.  This cover is only meant to be used when you are walking from your house to your car, store to car, school to car, and the like...it is meant to protect your baby from rain, snow, strong wind as you are walking from the places mentioned above.  It is not meant to be left on the car seat when you are driving, sitting somewhere, going to a long walk or stroller ride, or anywhere else for longer than a minut

Free Crochet Pattern: Valentine's Day Headbands

I made these adorable Valentine's headbands for my daughters.  For three free crochet headband patterns and how I made them, see below! I saw the cutest heart headband floating around Pinterest and decided to make one for each of my daughters.  The tutorial for the heart headband is here and the original heart pattern is here . But instead of using an elastic headband, I decided to use a crochet one.  I made some of these last year for my girls to wear at Easter and they turned out well so I was excited to make more. Here are my hearts: For the red one, I used Vanna's Choice yarn in Scarlet with a K hook.  For the darker pink, I used Red Heart Soft Baby Steps in Strawberry with an I hook.  For the lighter pink, I used Vanna's Choice yarn in Pink with a G hook. All of the headbands begin the same way.  If you are using 2 hair ties you have to join them together before you start joining the yarn onto the hair tie. If you are using one hair tie, you can beg